tag:blogger.com,1999:blog-5783985865082712242.post9110071791891912076..comments2024-03-24T19:52:50.881+00:00Comments on Irregular Wars: First foray into 3D printed figures - a zombie dwarfNichttp://www.blogger.com/profile/03601895895569143103noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-5783985865082712242.post-75893650186209910462020-05-26T06:33:00.220+01:002020-05-26T06:33:00.220+01:00It can sometimes be a bit of a lottery, I have see...It can sometimes be a bit of a lottery, I have seen some amazing figures 3D printed, and I have seen some epic failures as well. I have printed several 28mm figures with both my PLA printers and the results have been more than acceptable, but not what I would call commercial standard.The Old Gnomehttps://www.blogger.com/profile/16919941832280579592noreply@blogger.comtag:blogger.com,1999:blog-5783985865082712242.post-36300661562767605312020-05-25T19:27:30.073+01:002020-05-25T19:27:30.073+01:00I suspect that is good advice, but this figure was...I suspect that is good advice, but this figure was printed and sent by the manufacturer. I would be less disappointed if I'd bought a file and printed it myself, as I'd then be able to try printing again.Nichttps://www.blogger.com/profile/03601895895569143103noreply@blogger.comtag:blogger.com,1999:blog-5783985865082712242.post-42693125988339616302020-05-25T18:49:03.753+01:002020-05-25T18:49:03.753+01:00TBH, I`m tinkering for a few months now as well wi...TBH, I`m tinkering for a few months now as well with a printer (PLA one), until you mastered the tricksies, head to either Thingiverse, or to user MZ4250 on Shapeways, for a lot of free stuff to practice on. <br /><br />So far, as i`m still all thumbs on the printing level, that's what I am doingTomsche69https://www.blogger.com/profile/17175996032103612678noreply@blogger.com